• Male
  • Muenchen
  • Germany

Druckgott's Friends

  • Colin
  • Felix Meissner
  • Steven Gottlieb
  • basshead
  • John Leichty
  • Andrew Radford
  • Jason Short
  • Doug Weibel

druckgott's Discussions

Ardupilot Mega V1.4 (Red Board) RC-Inputs use as Potentiometer Inputs

Started this discussion. Last reply by druckgott Jun 2, 2012. 1 Reply

Hello,i want connect at least 4 Potis at Ardupilot Breadboard (i have only the red Board) and send its values via USB to PC.USB-Transmit works in steps of 1,5 sec but i think there has to be a…Continue

Tags: Potentiometer

Bug with 1.1.73 and Loiter Speed - Loiter P maybe inverted?

Started this discussion. Last reply by Michael Oborne Apr 22, 2012. 1 Reply

Hallo,I use 1.1.73 and AC 2.5.4If I check Tune CH6_Loiter_P the Loiter P don´t change, it Changes the Loiter speed.In what unit is Loiter speed? m/s?And is Loiter P with 2.0 default normal before it…Continue

Bug on CH7 MP Option für min max

Started this discussion. Last reply by Michael Oborne Apr 6, 2012. 1 Reply

Hallo,today I have used the MP and tune Travelspeed.I set value min to 0 and max to 6.0Then I change the value via ch7 and read the params again.if i´m on 0 it´s 0 if I put it put to 100% it´s not 6…Continue

Button to clear Eprom

Started this discussion. Last reply by Michael Oborne Apr 22, 2012. 4 Replies

Hallo,  is it posible to make a Button for clearing the eprom manually? thxdruckgottContinue


druckgott's Page

Profile Information

About Me:
Please tell us a bit about your UAV interest
multiwii and arducopter

Druckgott's Blog

How to burn a bootloader for APM2560 or APM1280 with a Pololu USB AVR Programmer

Posted on September 20, 2011 at 11:00am 1 Comment

I have a Atmega1280 Board with the IMU. On uploading the firmware 2.0.41 from Arducopter I get an error in MP.

After this MP can´t get my AMP version. So I decided to test it with arduino 22 and I get this error:


avrdude: stk500_getsync(): not in sync: resp=0x00

I testet many times and read many threads.


After testing…


Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service