• Male
  • Germany
  • Blog Posts
  • Discussions (29)
  • Groups
  • Photos
  • Photo Albums
  • Videos

jjohow's Discussions

After Calibration Motors keep beeping!

Started this discussion. Last reply by Bill Mar 14, 2013. 3 Replies

Hi!Sorry... this is getting strange, I know.But after I just calibrated my TX with the APM 2.5 the motors started spinning at low RPM.I disconnected the the power source (5 V BEC) and than the…Continue

Tags: calibration, after, Beeping, Motors

Altitude problem

Started this discussion. Last reply by Sean Headrick Mar 11, 2013. 3 Replies

Hi!I know this has been discussed before but somehow I could not find the old discussion.After having calibrated my APM 2.5, when I go out flying, the middle position of my throttle stick makes my…Continue

Tags: problem, alt, 2.5, Apm

Slow hight oscillations on APM 2.5 - what to tune?

Started this discussion. Last reply by leonardthall Jan 28, 2013. 1 Reply

Hi there!Today I mounted strong motors on my DJI 450 flame wheel: 2838 /1080KV - 280W with 11x5 carbon props. I am very happy with the flight-performance except for the slow oscillations in…Continue

Tags: oscillations, hight, 2.5, APM

Motors beeping after change to PPM-Sum

Started this discussion. Last reply by Gregmaan May 1, 2013. 5 Replies

Hi there,I have a Graupner MX-20 which supports PPM-sum on Ch8. I wanted to get rid of too many cables on my RX. So I changed to PPM. I did it like shown in the Wiki, bridged signal Pins 2+3 on my…Continue

Tags: PPM, sum, to, change, beeping


jjohow's Page

Profile Information

About Me:
APM - newbie on 31/08/2011
Please tell us a bit about your UAV interest
areal photography

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service