max246
  • Male
  • United Kingdom
Share

Max246's Friends

  • Philip
  • Kevin Hester
  • Raimondo
  • leonardthall
  • Dave C
  • Marco Robustini
  • Jason Short
  • Randy

max246's Discussions

Using UBLOX C94 M8P

Started Sep 20, 2016 0 Replies

I was wondering if I could just wire the UBLOX  ( https://www.u-blox.com/en/product/c94-m8p ) to the input of the 3DR brain to get a centimetre…Continue

Override target Altitude holder

Started this discussion. Last reply by max246 Nov 7, 2013. 1 Reply

I am trying to override the target of the Altitude holder with a custom message from Mavlink but I am not sure how to do it.I was looking into the code and trying to find out which variable was…Continue

Altitude holder problems

Started this discussion. Last reply by Aerhead Sep 11, 2013. 10 Replies

I tried to move my flight mode to Altitude holder when I was flying but when I around 2 meters from the ground the drone tries to land.When I give some more power to adjust the altitude, the drone…Continue

Problem with Arducopter 3.0.1 and APM 1

Started this discussion. Last reply by Dave Jeffries Sep 21, 2013. 2 Replies

I have just flashed the new Arducopter 3.0.1 and I am trying to follow all the instructions to make my drone flying, but it is not stable.My acc values are between 6 and -6 ( that doesnt seem to be…Continue

 

max246's Page

Profile Information

About Me:
I am a developer
Please tell us a bit about your UAV interest
awesome

Max246's Blog

RC CAR+ARDUINO: The second prototype is ready

Posted on April 21, 2012 at 10:52am 2 Comments

 

Today I went to a mega store and I found this "broken" car for just 9.99 pounds, so I decided to buy it and replace the crappy car that I mounted all the stuffs.

 

The next week I will buy 1 ultrasound sensor, extension IO and a compass, them should help the car to drive in a specific direction ( i.e. to the north ) and I am going to avoid the…

Continue

RC Car with Arduino nano and a TB6612FNG

Posted on April 13, 2012 at 4:00pm 0 Comments

Hello guys,

this is my first post on this blog and I'd like to give some information about my new personal project. How you read on the title, the project is a RC CAR with Arduino nano that is controlled by TB6612FNG.

The final project will be a RC CAR controlled by Arduino nano and a few sensors, the big goal is to create a car that I…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service