• Male
  • wah cantt
  • Pakistan

Waqas's Friends

  • mahmood
  • Marianne Antonio
  • tshado
  • Ahmad Usman

waqas's Groups

waqas's Discussions

Multiplexer Easy star

Started this discussion. Last reply by waqas Jun 7, 2011. 6 Replies

i used the recommended plane for Ardupilot megaand was very disheart after taking the 2 manual flightfirstly i want 5 channel,and they send me 3 channel RCthen thrust of easystar is very low..it…Continue

Multiplexer Easy Star(help needed)

Started this discussion. Last reply by waqas Jun 4, 2011. 2 Replies

How can i increase thrust of easy stari tried twice in manual mode and after after just a minute its crashes..and nose is damageis there any way to increase EScafter the manual flight i want to try…Continue

Help neede with APM 2.12 code

Started this discussion. Last reply by Michael Oborne May 24, 2011. 1 Reply

hey when i compile this code APM 2.12 i found the following error'get_log_boundaries' was not declared in this scopecan somebody figure out this problem for me? i need urgent helpthanksContinue

Tags: codeproblem, mega, ardupilot, 2.12, apm


Started this discussion. Last reply by Christopher Seruge Aug 10, 2015. 22 Replies

When i put this command in config.h in ardupilot mega 1.0 code#define GCS_PROTOCOL GCS_PROTOCOL_LEGACYHappykillmore didnt show YAW of my imuwhen i put Standard in place of legacyit show yaw and…Continue


waqas's Page

Profile Information

About Me:
student BS(CS)
Please tell us a bit about your UAV interest
final project

Comment Wall (3 comments)

At 6:04am on January 22, 2011, mahmood said…
waqas, if you need help getting parts you can also check out DFrobot.com they carry some apm relating items, ordering from there is simple and will cost much less for shipping
At 1:04am on January 23, 2011, waqas said…

thnx br0ther...


At 12:49pm on May 24, 2011, DaveyWaveyBunsenBurner said…
No problem buddy!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service