Yiangos Yiangou's Blog (3)

Yet another Build log - Epp FPV Part 3

First of all I installed some magnets on the wings (so they can be detachable)

Then i took out some foam and glued some Velcro to make space for my 2 5000mah batteries

 

 And finally the Gopro pan/tilt mount :)…

Continue

Added by Yiangos Yiangou on May 28, 2011 at 6:28am — 6 Comments

Yet another Build log - Epp FPV Part 2

Electronics arrived today :)

Glued the back wing and shaped the foam for the rudder ( Is there any other way to mount the servo rather than gluing it to the foam?)

 

Installed the motor , which is a turnigy 35-42B 1250Kv, mount needs some hot glue…

Continue

Added by Yiangos Yiangou on May 5, 2011 at 3:09am — 8 Comments

Yet another Build log - Epp FPV

So my kit from HK arrived yesterday and I should note that this is my first build ( If you see terrible mistakes don't hesitate  to shout;))

 

Soldered the carbon rod using some super glue. I installed those holders just in case even though most probably am gonna put the elevator end radder servos on the wing itself

 …

Continue

Added by Yiangos Yiangou on April 29, 2011 at 1:00pm — 10 Comments

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service