Dr. Stewart Pid's Blog (3)

Fiberglass Easystar landing gear and fuse half joining.

Here the fuse halves are joined with masking tape and the inch and a half seam tape is applied to the bottom.

Landing gear being molded into the bottom and will be sanded smooth after resin sets. The long brush on top will be used to apply the seam tape to the inside top portion of the fuse.

Rear wheel temporary fit…

Continue

Added by Dr. Stewart Pid on March 3, 2010 at 12:32pm — 15 Comments

Easy Star Fiberglass Fuse

I'm in the process of making a mold for a easystar fuse. I used the replacement foam fuse from the local hobby shop and mounted it to a board, filled the pushrod channels and servo holes on the outside. Fuse plug is painted and waxed.

I must decide where to install hatches (if any). I still have the removable canopy as a seperate part, and will mold the wing insert seperately.

Added by Dr. Stewart Pid on February 7, 2010 at 4:37pm — 9 Comments

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service