Vikram's Blog (3)

How to change labview GCS Baudrate to 19200...

Hi all, i had to make little changes in program to get the data at 19200 baud rate...... so its all woking with wireless telemetry.. But the only problem is groundstation... how to change baud rate of ground station. Since its in labview so facing problem of changing its baud rate i have its source code also but cant get how to change.. ..or is there any software emulator to get data on 19200 and reproduce on other serial port at 57600 for GCS.. Suggestions please ..

Added by Vikram on August 28, 2009 at 6:15am — 11 Comments

Done a air test today

Today i have done a ground test and it shown good results on ground navigation test it sensed the location i changed code little bit for navigation so that it shows the waypoint achieved with the buzzer beep. And it was succesfuly alarmed me the waypoint captured . The next step i did i load 2.0 version and i have fma xy sensor, and no telemetry so used buzzer for ground test navigation. Well i put the original code of jordi of 2.0 ver and i just did the settings as prescribed in 2.0 user… Continue

Added by Vikram on August 13, 2009 at 4:18am — 11 Comments

Changed the 2.1 for 2.0 hardware features.....

Hi all, i m ready for the ground test.Before starting i would like to clarify few things here..



I dont have Z sensor and air speed sensors soofcourse no throttle control then also... I was ok with version 2.0 but since i would like to add the config utility feature without increasing any hardware. So i made few changes in 2.1 version so that it can work successfuly with 2.0's hardware(only XY sensor).

I have made these changes please confirm is it right and please tell me if any… Continue

Added by Vikram on August 3, 2009 at 9:04pm — No Comments

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service