Wendi Smol's Blog (4)

Some pictures of the TERN build

Cutting of corner reinforcements. They will be glued into the fuselage to allow the rounded bottom shape without loosing the strength of side and bottom connection.



Start of the inlet duct for the fan.



Inlet duct ready cut.



Trimming of fuselage front with hot wire. If the temperature of the wire is high enough it cuts through the PU… Continue

Added by Wendi Smol on November 5, 2009 at 6:00pm — 16 Comments

TERN UAV 3 details for the 3D experts?

Hi all



here are some detail infos for the TERN fuselage, which may help to make some 3D drawings. All my drawings are done in Corel and can export in DXF or PDF format, so these formats are here as well. I would appreciate if you could give me some feed back of what helps you.…







Continue

Added by Wendi Smol on November 1, 2009 at 3:12pm — 3 Comments

Modularity, Versatility, Affordability

Here I have drawn some ideas of how to arrange wing and fuselage (shoulder wing or "middle" wing. There is also the possibility of adding a bottom pan to the underside of the fuselage to create a water plane for the water lovers. At least you have a chance to rescue your expensive equipment after a dunk. Undercarriage can be either left off or fixed depending on your take off ground; I will make a retractable UC as well (for the high speed runs :-)).…



Continue

Added by Wendi Smol on October 23, 2009 at 1:08pm — 6 Comments

Building a small UAV from foam and fiberglass the cheap way

A little drawing of how it will look:







Now some building photos:









How to get the pictures… Continue

Added by Wendi Smol on October 22, 2009 at 8:30am — 17 Comments

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service