Foam Tail Pusher

Range check is always a god idea, especially when using an new rx!
Do not think there will be any more flight test this week due to bad whether, plans are to scale up the frame to host APM.   
My Hitec minima range is horrible 15 m at Aurora 9 Tx at full power I tested whit rx, battery and one servo.

Anyone any ideas?

 

Project objectives

1. Easy build 2 hour + CNC cutting

2. Dead cheep

3. FPV APM

Anyone else interested in testing the frame let me now.

Views: 1300

Comment by Crashpilot1000 on September 28, 2012 at 9:46am

Great kit on the 2nd photo - where can i buy it ? -Rofl

Comment by Peter Meister on September 28, 2012 at 10:56am

Looks like the flight was not very successful i.e. picture #2. :) The frame looks good, I like it. What is the AUW of it ? with gear no APM..... 


Developer
Comment by Kabir on September 30, 2012 at 5:05am

Cool, but pic #2 not so cool. Jokes aside, the frame look(ed) good and I'd be interested in testing it, albeit with a better radio, so as to avoid pic #2 :)

Kabir

Comment by Patrik Ekblad on September 30, 2012 at 2:31pm

The span 1000 mm and AUW is 500g with 1100 mAh battery camera and video rx, the model on the second photo is lighter!

No worries I got 2 more to take apart, before I have to warm up the foam cutter. The weather in sweden this time of year is very bad, raining cats and dogs and windy. If any of you guys got a CNC foamcutter I be happy to share drawings and nc files.

Comment by Mike on July 1, 2014 at 1:13am

waht software you use to your foam cnc cutter   GMFC ??

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service