Remzibi OSD now in stock at the DIY Drones store

Hi everybody! I'm very happy to announce that the Remzibi OSD DIY Drones variant is now in stock in the DIY Drones store!

Our version is fully compatible with the original design and will work with Happy Killmore's config tool.

Our price is $89.99, this includes a custom FTDI programming cable and a set of pin headers.

Links and full feature list are available on the product page.

We hope you enjoy this one, and as always, feedback is welcome!

Views: 7273

Comment by Jordi Muñoz on December 24, 2011 at 8:58pm
You forgot to mention that you solved the heat problem with a Switched power regulator!!!

Comment by Jordi Muñoz on December 24, 2011 at 8:59pm
@John Seaman for that you should try minimOSD
Comment by penpen on December 25, 2011 at 3:55pm
Comment by vilnis.lauva on December 27, 2011 at 12:29am

BTW, "Remzibi OSD cable ($14.95 value!)" is the ftdi cable ? If so, most of us have this (I have even two), so, it will be very nice if you can provide without it, the price than will be even more nice.

Comment by Sam Kelly on December 27, 2011 at 12:50pm

Vilnis, the cable included with the Remzibi OSD is different. It's still an FTDI cable, but with a 4-pin female header on the other end instead of the usual 6-pin (this was done to keep compatibility with the OTi cable that the original Remzibi used). You can still use your standard FTDI cables but will have to use some extra wires to make the required connections.

Comment by Jordi Muñoz on December 28, 2011 at 3:22pm

@Johann, The MiniOSD is about to be released. They are fixing some little heat problems...

Comment by Tomas Soedergren on December 29, 2011 at 3:00pm

Jordi, good to know that MiniOSD is soon available.

I hope that mavlink protocol will come with realtime pack current data, since that is an system parameter of interest.

Is there anything (in AC environment) that the Remzibi can do that the MiniOSD can´t?

Comment by Cool Dude on December 31, 2011 at 2:36pm

Is it possible for you to release the schematics of this board? I would like to study it. If you cannot then I do understand as this is from Happy Kilimore rather than from diydrones.


Comment by Paul Mather on January 1, 2012 at 7:32am

This is not from me. I wrote software for the PC that you use to configure it. Remzibi designed and built the original boards. This version is from DIYdrones and I suspect they will release the files for it.

Comment by Ed Kirk on January 6, 2012 at 7:38pm

I received my Remzibi OSD 3DR today and looking for instructions on how to connect it to my APM2.  I can't seem to find any instructions for the electrical wiring on the Remzibi OSD 3DR, there is a note in the "Store" about the silk screen print error and that is confusing.  "RSSI" is between motor battery and the coms which "+.-" is it refering to?  I have searched the DIY site and can't find anything under Remzibi OSD 3DR.  There is a link for instructions in the Store but it shows a different version of the OSD.

Thanks,  Ed


You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service