Mirko Denecke's Comments

Comment Wall (4 comments)

At 3:02am on July 20, 2015, Jon Paul Llamas said…

Our Program is excited about your work, and we thank you for all the time you have put into sharing your build and helping others share your experience..

Keep up the Good work.

At 11:01pm on June 25, 2016, Michael Tilse said…

Hi Mirko,

Thanks for adding me.

Hi Mirko,

Thanks for replying to my comment. 
The pressure sensor that I want to use on the ROV is this one: MS5837-30BA Ultra small gel filled pressure sensor. It has an I2C interface
Thanks!
At 2:58pm on June 7, 2017, Ivan Arenas said…


Good afternoon Mirko, look I'm experimenting with drones, I have a BEAGLEBONE BLUE, where I can see a wiring diagrame, thank you.

At 11:48am on June 10, 2019, FÁBIO PEREIRA said…

I saw on the Linus page that he stopped selling the BBBmini kit, so I ordered a shenzhen2u, it arrived in 30 to 40 days.
In the kit, it features a mounting bracket for the HC-SR04, my question is: should it be mounted in front of the drone, to avoid obstacles / collisions? Or should it be mounted below the drone for the altitude hold function? Or can I put 2 sensors: one to avoid frontal collision and another to hold altitude?
I found in Banggood a breakout board with the I2C and UART outputs:
https://www.banggood.com/en/Flight-Controller-Obstacle-Avoidance-Sensor-Altitude-Ultrasonic-I2C-Module-for-PIXHAWK-APM-RC-Drone-p-1433249.html?rmmds=search&cur_warehouse= CN
Could it be used?

I also read about the US-100, which seems to me to be more accurate. Can you tell me if I can like it?

Well, there are still many doubts ...

Thank you for your attention.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service