Ankit Sarvaiya
  • Male
  • Toronto, ON
  • Canada
Share
  • Blog Posts
  • Discussions (5)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Ankit Sarvaiya's Friends

  • kw SO
  • Doug Walmsley

Ankit Sarvaiya's Discussions

Pixhawk motor test tab not active

Started this discussion. Last reply by Chris Anderson Dec 16, 2017. 1 Reply

Evening all,Not able to test the motors individually as this tab is not active?Any reason why I am having this error?Please advise,Continue

Tags: inactive, motor, px4

Pixhawk 2.1 with default power brick used with SUNNYSKY X3508S KV700 BRUSHLESS MOTOR

Started this discussion. Last reply by Ankit Sarvaiya Dec 9, 2017. 2 Replies

Afternoon all,I am trying to run Pixhawk 2.1 on my quadcopter with Sunny sky motor listed here: …Continue

Tags: sunnysky, apc1238, module, brick, power

APM 2.5 voltage across TPS79133

Started this discussion. Last reply by kunkun789 Nov 5, 2013. 4 Replies

Hi,My APM 2.5 recently gave up on connecting with Mission Planner using 3DR radios. I did my research and came across finding voltage across this chip that turned out to be "not right".According to…Continue

 

Ankit Sarvaiya's Page

Profile Information

About Me:
I'd like to take UAV standards to a whole new level.
Please tell us a bit about your UAV interest
Have built some and planning to build tons more.

Comment Wall (4 comments)

At 7:30am on August 19, 2014, Doug Walmsley said…

I can help, but there has to be an understanding that if the damage is beyond a capacitor, that I do not have the tools (Oscilloscope) to troubleshoot it any further.  I also wish to be not liable for the outcome of your GoPro camera.  I did repair my GoPro2 camera and I can open it and inspect for a burnt smt capacitor and more than likely repair it.  It's up to you, I'm willing to give you some help with it. 

At 7:32am on August 19, 2014, Doug Walmsley said…

If you cover the mailing both ways, I will do it for no charge.  I don't mind helping fellow UAV'ers.

At 4:39pm on August 19, 2014, Ankit Sarvaiya said…

Hi Doug,

Thanks for the helping hand! I understand the risk involved with this and it would be wonderful if you could fix it.

I can ship to you and back and like I even said, any additional cost that you come across, I can cover.

If you could message me your location, I will have it ship to you by tomorrow.

Thanks!

- Ankit 

At 6:50am on September 10, 2014, Doug Walmsley said…

Ankit,  Have you mailed the GoPro yet?  Never received your message indicating it was sent and I am looking for it in the mail but haven't seen it yet.

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service