Anthony Webber
  • Male
  • United Kingdom
Share
  • Blog Posts
  • Discussions (5)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Anthony Webber's Discussions

ArduCopter - Changing motor spin direction

Started this discussion. Last reply by Andre K. Jul 18, 2018. 1 Reply

Although I believe there is no option to change motor spin direction in Mission Planner, can I simply first use the SERVO1_REVERSE parameter (or whichever numbers are appropriate) to do this, save my…Continue

 

Anthony Webber's Page

Latest Activity

Andre K. replied to Anthony Webber's discussion ArduCopter - Changing motor spin direction
"Assuming you mean brushless motors with multirotor firmware running on PWM controlled ESC's there is no way autopilot can command them to change direction. If you cannot swap wires on incorrectly connected motors, the only option is to…"
Jul 18, 2018
Anthony Webber posted a discussion

ArduCopter - Changing motor spin direction

Although I believe there is no option to change motor spin direction in Mission Planner, can I simply first use the SERVO1_REVERSE parameter (or whichever numbers are appropriate) to do this, save my settings, and then run Mission Planner setup?I need a solution that does NOT involve physically rewiring.Or perhaps I must dig into the program and rebuild it with this hard-coded?Advice appreciated.-- AnthonySee More
Jul 17, 2018
Anthony Webber replied to Randy's discussion PixRacer with Ardupilot
"Hi Mark, Ah gotcha regarding the frame rate. I just purchased the FrSky 4 channel one you suggested, so we'll see how we go with that. Any idea of its frame rate?"
Apr 11, 2018
Anthony Webber replied to Randy's discussion PixRacer with Ardupilot
Apr 10, 2018
Anthony Webber replied to Randy's discussion PixRacer with Ardupilot
"Wow, that's fantastic, Mark! Thanks so much. I only need two extra channels, and space is so limited. I need to get a very tiny converter, but this is great :)"
Apr 10, 2018
Anthony Webber replied to Randy's discussion PixRacer with Ardupilot
"Is there any way at all that the PixRacer could be miraculously transformed such that it'll handle 8 ESC signals? I need something small for a coax octocopter that will a) run ArduCopter and b) fit the 30.5mm x 30.5mm (hole centres) board…"
Apr 9, 2018

Profile Information

Please tell us a bit about your UAV interest
Where do I start?
Hometown:
Bristol

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service