Dallas Stroud
  • Male
  • Denton, TX
  • United States
Share
  • Blog Posts
  • Discussions (2)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Dallas Stroud's Discussions

3DR Power Module not reading voltage in Mission Planner

Started this discussion. Last reply by Dallas Stroud Nov 12, 2014. 1 Reply

I recently got a PX4 and a 3DR custom built quad.  I'm using all 3DR parts other than the props.  My issue is that I can't get mission planner to show what voltage or current flow, it only shows 0.0.…Continue

Tags: Module, Power, 3DR

 

Dallas Stroud's Page

Latest Activity

Dallas Stroud replied to Dallas Stroud's discussion 3DR Power Module not reading voltage in Mission Planner
"Never mind. I was not correctly stating what I had.  I was under the assumption that the PX4 and Pixhawk were the same thing.  My mistake.  My Pixhawk has PX4 stamped on the side so I had the pin configuration set for a PX4.  i…"
Nov 12, 2014
Dallas Stroud posted a discussion

3DR Power Module not reading voltage in Mission Planner

I recently got a PX4 and a 3DR custom built quad.  I'm using all 3DR parts other than the props.  My issue is that I can't get mission planner to show what voltage or current flow, it only shows 0.0.  I have replaced the power module with a brand new one but still have the same issue.  I'm also using a 3DR power distribution board.  I have the 6 pin cable from the power module going into the power spot on the pixhawk.  And to the best of my knowledge I have all the settings correct in mission…See More
Nov 11, 2014

Profile Information

About Me:
Been flying RC for 15 years. Multirotors for 3 years. Just getting into automated flight
Please tell us a bit about your UAV interest
I'm interested in flying some fully automated missions and want to integrate my rc truck and plane as well!
Hometown:
Denton, TX

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service