• Male
  • United Kingdom

Dave's Groups

Dave's Discussions

Stuck on "ERASING LOGS" during startup

Started this discussion. Last reply by Chris Anderson Feb 21, 2012. 10 Replies

Hi All,Recently my APM board has not been starting up properly. When I connect it to a serial terminal I can see that it get's stuck on:Init ArduCopter…Continue

Full state vector from IMU

Started this discussion. Last reply by Rui Manuel Cravo Marques Feb 6, 2012. 4 Replies

Hi guys,I've been playing with a 9dof board I was using for some custom control work I had on and was wondering if it's possible to extend the standard attitude [pitch,roll,yaw] vector we get to have…Continue

3DR frame feedback

Started this discussion. Last reply by Thomas Kramm Feb 9, 2012. 3 Replies

Hey All,I've been flying on the new 3DR frame for a couple of weeks now with an hour or so of flight time and have collected my feedback on the frame.Battery MountingThe strap that comes with the…Continue

Not getting any output to my ESCs

Started this discussion. Last reply by Dave Nov 5, 2011. 7 Replies

I've just finished wiring my boards up and mating them with my airframe and (tested working) ESC+motor combos but I can't get the board to drive my motors. I've done manual calibration and driving…Continue


Dave's Page

Profile Information

About Me:
Professional programmer and flight/ai/drone enthusiast.
Please tell us a bit about your UAV interest
Flying is cool, so since I can't do it I want to make thins that do :)

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service