Frank
  • Male
  • rr
  • Italy
Share
  • Blog Posts
  • Discussions (41)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Frank's Friends

  • Olivier ADLER
  • Michael Oborne

Frank's Discussions

Please Help with new RC_Channel_AUX library: stopped my code from moving servos

Started this discussion. Last reply by Larry Grater Mar 4, 2012. 1 Reply

new aux implementation made my old code obsolete.I wish to move a servo on chX where X is 6to8,chX is NOT connected to radio so I can't calibrate it with calibration routine, I use parameter with gcs…Continue

Use planner with MAV downlink only

Started this discussion. Last reply by Frank Dec 6, 2011. 2 Replies

I only have the downlink from apm (frsky, 10hz attitude, 5hz gps and other), HKgcs is working fine, planner always gives me errors when try to connect.It is probably expecting a reply from APM (no…Continue

only ch8 seen from apm but passtrough is ok, always in failsafe?

Started this discussion. Last reply by Frank Dec 4, 2011. 2 Replies

with planner 1.0.99 I upload 2.26 arduplane code into 1.4 hw, reset and than radio tab.I can move only the ch8 bar, other at 1500.If I go over 1750 on ch8 it correctly go in passtrough mode and I can…Continue

wrong values acc

Started this discussion. Last reply by Chris Anderson Jul 11, 2011. 4 Replies

tested with copetr and plane and adc test:someway z seems coupled with y in a strange manner.when a negative y value is present z acts in a stepped way, at certain values it drops by about 500 than…Continue

 

Frank's Page

Profile Information

About Me:
nothing special :)
Please tell us a bit about your UAV interest
algorithm fixation

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service