R. L. is now issuing videos flying with the SOLO 3DR drone. For me it looks like he is now low key with Helis or not at all.
What kind of donation will be necessary to get a stable helicopter firmware upgrade after the still present …"
If you new to the pixhawk and you are not willing going through the pages of the manual and the info on this forum you have to wait for Robert Lefebvre,s release of the next video he has promised will coming soon.
The first setup…"
I have done the FW 3.3.2rc1 test with the TREX Align 700E DFC yesterday.
Same test and same good result as with the 500 Heli, but windy.
The 700 was also perfectly mechanically trimmed before. I am using the Align Digital Pitch Gauge -…"
"After weeks of to much wind I was be able to test first time the newest FW v 3.3.3rc1 today.
I did my usual Fl.modes : Stab, AltHold, Loiter, and RTL.
Everything was very good and the auto landing was perfect including motor turn off (…"
Sorry coming back to you so late.
Tonight I have tried with my second Pixhawk setup ( both trad. Helicopters)
and it worked by the first attempt.
Same setup, same cable, same LIDAR.
Still have to find the reason why it did not work…"
"Felix, I am going to check the param. but just let me get this absolutely right.
In the first reply to me you write:
The sensor was connected to Main Out 5& 6. --- I assume that was the answer what the problem was with Stephan.
I have used AUX…"
"Thank you for the reply, Felix.
I can answer all your questions with Yes. ( 470 ohm resistor)
There is a Zener diode at the rail preventing spikes because I have 5v attached before as a backup for the pixhawk.
That has worked always but could the…"
was war die Ursache mit dem LIDAR von Stephan?
Ich habe genau das selbe Problem. Ich moechte nur wissen, ob das LIDAR Lite eventuell kaputt ist, damit ich es zurueckschicken kann, wenn absolute keine Werte herauskommen. Installation ist…"