• Male
  • United States

Frenchguy's Friends

  • Jesse
  • jacekheli
  • Hein
  • Peter Seddon

Frenchguy's Groups

Frenchguy's Discussions

XBee & telemetry question

Started this discussion. Last reply by Paul Feely Jan 17, 2014. 6 Replies


Frenchguy's Page

Frenchguy's Blog

Pixhawk Futaba T8J 6 modes configuration with 2 switches (C & D)

Posted on February 23, 2014 at 6:00pm 8 Comments

Disclaimer: I don't know what I am doing. This seems a bit more complicated than other solutions I have found (since I had to use the Sub Trim) but it works with what is the latest T8J firmware (I think I have the latest but cannot confirm since I see no way of knowing the version # or upgrading the firmware).

These are my settings. I had to use the Sub Trim to move the PWM output of the C switch in the middle position so I would have access to the third mode with D…


Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service