Gerrit Jan Baarda
  • Emmen
  • Netherlands
Share
  • Blog Posts
  • Discussions (72)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Gerrit Jan Baarda's Discussions

Mission planner on linux will not let me conncet because I can´t choose a baud rate.

Started this discussion. Last reply by Andre K. Jul 29, 2013. 1 Reply

Hi,I'm running Megaplanner on kubuntu 13.04.Everything seems to go fine on startup. However I'm not able to use my telemetry because the arrow on the drop down box for choosing the baud rate is not…Continue

I think there is something wrong with my compass, how can I check?

Started this discussion. Last reply by Gerrit Jan Baarda Jan 6, 2013. 2 Replies

A while ago I had a bad crash (prop failure), and now my copter is not loitering properly anymore.What happens is that it initially does fine for a few tens of seconds and then it starts circling…Continue

How to run mission planner on debian

Started this discussion. Last reply by think linux Mar 31, 2013. 13 Replies

I had a lot of trouble getting mission planner to run correctly on my linux 64bit debian sid system.After lots of fiddling and tweaking I found installing ONLY mono-runtime…Continue

Pid configuration in recent Mission planner

Started this discussion. Last reply by Michael Oborne Jun 28, 2012. 1 Reply

In more recent versions of the mission planner there are two ways of entering PID values, one is the 'arducopter config'  tab that is more or less the same as the older versions, and then there is…Continue

 

Gerrit Jan Baarda's Page

Profile Information

About Me:
Mechanical Engineer, linux and open source enthousiast
Please tell us a bit about your UAV interest
I have been flying RC Aircraft for a long time, this is something new
Hometown:
Emmen

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service