• Beverly Hills, CA
  • United States

Haygood's Friends

  • Craig P.
  • Svein Alexander Frotjold
  • Doug Walmsley

Haygood's Groups

Haygood's Discussions

Carbon Fiber frames bad for radio reception?

Started this discussion. Last reply by Sam Arbizo May 21, 2015. 3 Replies

I understand carbon fiber can block radio signals.  However, I see a lot of carbon fiber frames out there.  Does CF block radio signals any more than aluminum does?  I can imagine that completely…Continue

Tags: signal, frame, radio, CF, fiber

MinimOSD and/or Mission Planner - set up Spektrum's RSSI - Pixhawk

Started this discussion. Last reply by David Schneck Aug 2, 2015. 5 Replies

Helloooooo.   So, I have a Spektrum DX7 radio talking to a Spektrum satellite receiver, which is plugged directly into my Pixhawk.  How can I get MinimOSD's RSSI field to show me how well the DX7's…Continue

Offline maps for Mission Planner

Started this discussion. Last reply by Brad Cooper May 5, 2014. 1 Reply

Hi. All.  I've seen the prefetch function for Mission Planner.  I'm wondering if there is a way I can just download "all the maps I'll ever need" at once and store them in case I need to use them…Continue

Setting Channel assignments at Pixhawk for Spektrum DX7

Started this discussion. Last reply by Henry Dec 7, 2015. 23 Replies

Hi all!  Thanks for all of the help you have already lent me in getting started with my 3DR Y6. The Pixhawk is looking for mode selection information to come to it via Channel 5, where it is finding…Continue

Tags: Flaps, Spektrum, DX7


Haygood's Page

Latest Activity

Haygood commented on Klaus Heinrich's group PIXHAWK
"Staying at low power, then shooting upward as you pass mid throttle sounds like typical behavior in alt hold mode.   You are requesting higher, and it throttles up suddenly to go from not flying to flying and climbing.  What flight…"
Aug 19
Haygood replied to Gene Stribling's discussion New to all of this Drones, I have a S-500 Drone. need help Missing Electronics ???? Pixhawk 100% ???? in the group PIXHAWK
"Battery, battery wires and/or current/voltage sensor, power distribution board and maybe another voltage regulator board if you need 5v for cameras and don't want to run them off of the pixhawk's…"
Feb 23

Profile Information

Please tell us a bit about your UAV interest
3DR Y6

Comment Wall (1 comment)

At 8:17am on September 15, 2014,

Good work,   keep it up.


DiyD support

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service