• Blog Posts
  • Discussions (19)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Jill's Discussions

Remove motor shaft on DIY Drones Motor AC2830-358, 850Kv

Started this discussion. Last reply by Coty Wood Apr 12, 2013. 19 Replies

Is the motor shaft removeable on DIY Drones Motor AC2830-358, 850Kv? If so, how would I remove the shaft? I have slightly bent a shaft, and have an extra motor. I was hoping I could just replace the…Continue

Position Accuracy in Loiter and Auto Modes

Started this discussion. Last reply by Jill Aug 2, 2012. 2 Replies

Do the accelerometer readings determine the position after the initial GPS read or does the copter rely solely on GPS readings for the loiter and auto modes?Also, I am in the process of fine-tuning…Continue

Quad can't hover with wind

Started this discussion. Last reply by Chris Anderson Aug 1, 2012. 2 Replies

My 3DR ARTF arducopter from Udrones will not stabilize against the wind. I have APM 1. The arducopter drifts with any wind in stabilize. Is there any PID settings I can change to correct this drift?…Continue

Arducopter Won't Follow Waypoint Mission in Auto

Started this discussion. Last reply by Jill Jul 19, 2012. 2 Replies

Which file(s) are the navigation equations located in the arducopter software?My Arducopter won't follow any waypoint missions in auto. It goes completely off course(30-40m). I also set the default…Continue


Jill's Page

Profile Information

Please tell us a bit about your UAV interest

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service