Jim Mullen
  • Male
  • Brimfield, MA
  • United States

Jim Mullen's Groups

Jim Mullen's Discussions

Is usable quadcopter flight possible above 13,000' (4000m)?

Started this discussion. Last reply by Matthew Elyash Jul 25, 2013. 1 Reply

Folks,A friend of mine is considering using a quadcopter in locations where ground level is 13,000' (4000m). Does anyone have any experience flying at that altitude? I guess this breaks down into a…Continue

What is the difference between 'reset' and 'erase' CLI commands?

Started this discussion. Last reply by Jim Mullen Apr 9, 2013. 2 Replies

I've read through the wiki but I'm still not clear on the distinction between the two commands and when would be the appropriate time to use them.I've upgraded from 2.8.1 to 2.9.1b. All my PID's and…Continue

Compass Drift Problem (or what is going on here?)

Started this discussion. Last reply by Louis Novy Jan 4, 2017. 2 Replies

Here's the specifics: APM 2.5, 2.8.1 Software, Mission Planner 1.2.40Mounted on a quad. The quad flies in stabilize mode very well. I'm hesitant to venture into any of the guided modes - here's…Continue

Tags: 2.8.1, apm2.5, drift, compass

A couple of noob questions about RCTimer 2.5 and Arducopter - if I may ask?

Started this discussion. Last reply by Chris Anderson Dec 26, 2012. 5 Replies

Hi,I'm new to the group and quadcopters, not new to R/C and have decent computer ability. Just a quick background. I've flown R/C for many more years than I'd care to admit. Planes, heli's, gas,…Continue


Jim Mullen's Page

Profile Information

About Me:
Long time R/C'er (planes, helis), ham radio operator. Always interested in playing with new technology.
Please tell us a bit about your UAV interest
Learn how to build/fly a quad/hex copter. Would like to play around with waypoints and automatic flying. Not sure I'll go FPV.
Brimfield, MA

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service