John L.
  • Male
  • Adelaide, South Australia
  • Australia
Share

John L.'s Groups

John L.'s Discussions

Motors cutout when testing

Started this discussion. Last reply by Wolke Oct 22, 2013. 3 Replies

HiI thought I would give -rc4 a go, but while testing, I noticed a 'problem' when switching into either Alt hold or loiter when the throttle is less than 50%.If I spin the motors up in stabilize mode…Continue

ArduCopter Mission Planner 1.0.68

Started this discussion. Last reply by Michael Oborne Sep 17, 2011. 12 Replies

Hi allAm I the only one or is the Mission Planner interface now running really slow.It seems to be working but the updates seem to be a couple of seconds apart making it sluggish moving around menus…Continue

Magnetometer orientation

Started this discussion. Last reply by John Church Jun 25, 2011. 1 Reply

My compass has East and West swapped which I suspect is because the AC2 code expects the compass to be component side down and soldered to the pins on the IMUI have noticed the AC2 code and CLI…Continue

Propeller size 10" / 12"

Started this discussion. Last reply by John L. Jun 22, 2011. 8 Replies

 I did a dumb thing (not the first time)I hurriedly ordered some spare props and obviously didn't look at the size too well when ordering.Instead of 10" I must have ordered 12" because I now have 2…Continue

 

John L.'s Page

Profile Information

About Me:
Electronic Engineer
Please tell us a bit about your UAV interest
Am totally absorbed by hovering aircraft and aerial photography
Hometown:
Adelaide

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service