Juampa
  • Male
  • Argentina
Share

Juampa's Friends

  • marcelo
  • Jason Short

Juampa's Groups

Juampa's Discussions

Mag offsets

Started this discussion. Last reply by druckgott Jun 22, 2011. 3 Replies

I need some help to understand how mag offset works, I read somewhere it's calculated while flying but I couldn't find about it on the wiki.Is it calculated in every flight or only after eeprom…Continue

Help, radio calibration

Started this discussion. Last reply by Juampa Jun 20, 2011. 1 Reply

I'm almost ready to fly, working on radio setup but I'm not able to calibrate channels 5 and 6.This is what I'm getting after calibration:Radio----------------------------------------CH1: 1112 |…Continue

Magnetometer not working

Started this discussion. Last reply by Joshua Ott Jun 15, 2011. 14 Replies

Hi, I've installed magnetometer to my APM board and is not working yet.It is soldered as suggested on the wiki, with pin headers to the board.Solder jumper already on 5V, VCC pin is at 4.86V and no…Continue

APM 1280 upload problem

Started this discussion. Last reply by Javier Robaina Nov 17, 2011. 23 Replies

Hi guys, we are having some problems uploading firmware with Arduino to APM 1280 board when the size of the sketch is more than 122880 bytes (0x1E000).I understand that bootloader starts at 0x1F000,…Continue

 

Juampa's Page

Profile Information

About Me:
Electronic Engineering from Argentina
owner of www.rcjuampa.com.ar
Please tell us a bit about your UAV interest
Interest in FPV, UAV flying and related electronics

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service