• Male
  • Marina Del Rey, CA
  • United States

Justin's Groups

Justin's Discussions

Powering Pixhawk servo rail from receiver

Started Aug 3, 2016 0 Replies

Hi Gents,I am writing this to get your feedback. Like many of you I am using OPTO Esc's in my build. I am powering the Pixhawk from the 3dr power module and in the past I powered the servo rail by a…Continue

falling from the sky

Started this discussion. Last reply by Andre K. Jan 1, 2016. 1 Reply

Guys I am desperately seeking your help! I have two Pixhawks with the same problem. When my quads take off and reach a low altitude hover, they both flip over and crash! This behavior was only…Continue

Zener Diode needed for Pixhawk?

Started this discussion. Last reply by Bill Bonney Oct 12, 2015. 1 Reply

Sorry, wasn't getting responses above and can't get straight answer. I have a quad using Pixhawk. The ESC's are OPTO, therefore I have a BEC on rail to peer them(and power control module for actual…Continue

Desperately seeking clarification

Started this discussion. Last reply by Bill Bonney Oct 13, 2015. 8 Replies

Finishing a new quad using Pixhawk with OPTO ESC's. Therefore, I'm using a seperate BEC(power control module for actual autopilot). I have no servos since it is a quadcopter. Do I still need to use a…Continue


Justin's Page

Profile Information

About Me:
Robotic Engineer
Please tell us a bit about your UAV interest
Search & Rescue UAV's
Los Angeles

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service