Marc LE BRET
  • Male
  • Combrit, Brittany
  • France
Share
  • Blog Posts
  • Discussions (83)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Marc LE BRET's Friends

  • Todd Spurgeon

Marc LE BRET's Discussions

UDP Connect broken with 1.3.41

Started this discussion. Last reply by Craig Elder Oct 2, 2016. 1 Reply

Hello,I use to connect via UDP on my Navio2-Pi board.Connection was OK with 1.3.39 but latest update broke it.…Continue

Google earth "end of life December 12, 2015" and APM

Started this discussion. Last reply by Ivan R Nov 8, 2015. 1 Reply

Hello,Do you still rely on Google Earth with mission planner?Do you have a "Plan B" as Google is not planning to support Google Earth API after December 12, 2015.Thanks,MarcContinue

Tags: APM, Earth, Google

APM2 and Futaba R6107SP PPM Sum

Started this discussion. Last reply by leachim Apr 20, 2012. 7 Replies

Hello,I'm new in the APM2 world, and I have some trouble between APM2 and my Futaba PPM Sum receiver.I activated PPM sum on the board (solder between PPM and CH5 pads), but no luck with it, no way to…Continue

 

Marc LE BRET's Page

Latest Activity

Marc LE BRET replied to Bruce Ardern's discussion Octocopter Transmitter Set Up
"You get it, RC transmitter send commands to the flight controllers (Up, Down, Right, Left,...). Flight controller send commands to the motors. https://www.rcgroups.com/forums/showthread.php?2429327-Basic-Introduction-to-Multicopters Enjoy, Marc"
May 24
Marc LE BRET replied to Bruce Ardern's discussion Octocopter Transmitter Set Up
"Octocopter or Quadcopter, the radio settings are the same. Follow the wiki: http://ardupilot.org/copter/docs/common-rc-transmitter-flight-mode-configuration.html#rc-transmitter-flight-mode-configuration All pertinent information is there."
May 22
Marc LE BRET replied to Dan Beich's discussion Telemetry Issues - Connecting a Navio2 to Flight Planner using Radio Telemetry
"Not easy. I have some modules (3DR or equivalent) and Comport is USB Serial Port (FTDI), version 2.12.0.0 26/08/2014, on a W10 setup."
May 14
Marc LE BRET replied to Dan Beich's discussion Telemetry Issues - Connecting a Navio2 to Flight Planner using Radio Telemetry
"Red blinking is data transmit.  When the two units are connected (mission planner), the two units have red light blinking. If connection is not established, ground red (near the serial plug) is off. It could be a bad COM port selection or…"
May 14
Marc LE BRET replied to Dan Beich's discussion Telemetry Issues - Connecting a Navio2 to Flight Planner using Radio Telemetry
"Steady green indicate the two units are paired. Can you look at https://docs.emlid.com/navio2/common/ardupilot/installation-and-running/#specifying-launching-options and confirm Telem2 line is uncommented in your arduxx file. If there is…"
May 13
Marc LE BRET replied to Nick Donnelly's discussion APM 3.5 Instant Flip on Takeoff
"Hello, Parameter reversed: could be part of QGroundControl radio calibration process.  Motor problem: It also could be a bad ESC calibration. You can redo ESC Calibration with a receiver and a 4 in 1 plug or repeat the process for each…"
Apr 3
Marc LE BRET replied to Nick Donnelly's discussion APM 3.5 Instant Flip on Takeoff
"There is something. In the Edge RC settings, RC2 (Pitch) is reversed. It should not. You have to reverse the Pitch channel of your RC Tx. You will have to redo the RC Calibration after changing your RC Tx…"
Apr 1
Marc LE BRET replied to Nick Donnelly's discussion APM 3.5 Instant Flip on Takeoff
"Hello, Try to share your .bin file (downloaded from Edge). From first look at the .log file parameters, you use default parameters. Can you share a picture of your quadcopter (from above) and confirm Prop size and take-off weight. Best place to…"
Apr 1
Marc LE BRET replied to Max Wolf's discussion Pixhawk 2.1 Return to Nearest Waypoint?
"Hello, See Rally Point feature, http:http://ardupilot.org/copter/docs/common-rally-points.html#overview/ Marc"
Jul 19, 2018
Marc LE BRET replied to Paul's discussion Lots of pins, little documentation
Jul 6, 2018
Marc LE BRET replied to Darius's discussion Coax dodeca-copter on Arducopter 2.x
"ContraRotation on a flat Hexa or Octa is for Yaw control. Developpers choose to have contrarotatings motors on Y6 then Octo-Quad X config for thrust distribution staying even during Yaw. As 12 motors control card are not common on the market, your…"
Aug 9, 2017
Marc LE BRET replied to Walter Andreas's discussion Xaircraft x650 Center Software
Apr 5, 2017
Marc LE BRET replied to Dusty Kirschmann's discussion Futaba Sbus
"Hello, If you google "R7008SB pixhawk" you will find old information with your same problem. I have a 18SZ (had a 14SG) and I do not use R7008 or 3 sBus2 receivers on my multicopters, but R6202SBW or R6303SB. I have telemetry via 3DR…"
Mar 13, 2017
Marc LE BRET replied to Dusty Kirschmann's discussion Futaba Sbus
"? What is your Arducopter card ? No sBus in with APM, only PPM ?? Is sBus Rx mode configured  ?? See Futaba Rx user manual for that, Marc"
Mar 12, 2017

Developer
Craig Elder replied to Marc LE BRET's discussion UDP Connect broken with 1.3.41
"We are rationalizing out support locations. Please post to http://discuss.ardupilot.org/c/ground-control-software/mission-planner ;"
Oct 2, 2016
Marc LE BRET replied to Edmond H. Pepper, P.E.'s discussion Purple Polygons in APM Mission Planner
"T is for Temporary. For permanent information, you have to look at sectionals maps. http://aeronav.faa.gov/content/aeronav/sectional_files/PDFs/ Umatilla airspace:"
Oct 1, 2016

Profile Information

About Me:
Retired Air Force Transport Pilot. Back to R/C models since retirement.
Please tell us a bit about your UAV interest
Quad and Y6 Copters.
Hometown:
Combrit

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service