"Hi, My 2 cents, I have gone to a high voltage 6 cell systems= lower current, lighter wiring, less current induced magnetic interference, low kV motors more efficient props.but most hardware is not designed for the higher voltage so be aware of your…"
Wow, interesting. So you're switching between the two servo outputs mid-flight using a multiplexer? How does this work in practice? Do you first use Baseflight to get it up to hover, then apply some forward thrust, while switching to the iNav controller?
Also, are both controllers driving the tilt servos? If so, how are those connected in the firmware? I didn't know that Baseflight supported tiltrotors.
Thanks for all the info!
No comments yet!
You need to be a member of DIY Drones to add comments!