Steve Gemmell
  • Male
  • Auckland, Nrth Island
  • New Zealand
Share
  • Blog Posts
  • Discussions (14)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Steve Gemmell's Discussions

Set Home Location in Mission Planner 1.2.65

Started this discussion. Last reply by Steve Gemmell Aug 3, 2013. 2 Replies

Hi All,I have a problem that am struggle to get around.When I power up the APM (its the AMP1 I use) and connect to Mission Planner, the altitude in the Flight Data page is relative, and is sitting…Continue

Arduplane 2.26 Failsafe whilst in Manual

Started this discussion. Last reply by Steve Gemmell Dec 2, 2011. 1 Reply

Hi All,I have been testing out 2.26 (APM 1.0.95) in the various failsafe modes, and have found that if the radio goes to failsafe (via throttle) when the Arduplane is in manual mode, it as per the…Continue

Ailerons on Channel 5 and 6

Started this discussion. Last reply by Doug Weibel Dec 7, 2011. 3 Replies

I have had a good troll through the attitude.pde code (2.24) and see that support is there for putting a second aileron servo on channel 5 or 6, driven from channel 1.I am basing the following…Continue

 

Steve Gemmell's Page

Profile Information

About Me:
Electronics enthusiast.
Fly Indoor, at the moment, but have always wanted to delve into autopilots.
Have flown in a (real) P51 and done 3 hours in a Tiger Moth with a wonderful pilot who did a full aerobat routine, and let me fly it. Just fabulous.
Used to fly a 1/8 P51 years ago.
Please tell us a bit about your UAV interest
General interest in the technology. Cutting edge stuff you guys are doing, and just want to be part of it. Always loved electronics and this is a marriage of physics/electronics/aerodynamics/building and pure gut feel. Just wonderful!
Hometown:
Auckland

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service