Ulf
  • Male
  • Germany
Share
  • Blog Posts
  • Discussions (9)
  • Groups
  • Photos
  • Photo Albums
  • Videos

Ulf's Discussions

ASCII Output

Started this discussion. Last reply by Ulf May 2, 2009. 2 Replies

 

Ulf's Page

Latest Activity

Ulf replied to John Arne Birkeland's discussion Servo problem with the new red (328) cards?
"Hi, i guess i was a bit too quick with my foto demo. now i got a video: Video (The Video is mirrorored) running the 2.1-code out of the box. Can anyone reproduce this? Is this normal? I'm still waiting on the remote and i wanted just test the…"
May 3, 2009
Ulf replied to John Arne Birkeland's discussion Servo problem with the new red (328) cards?
"Ups..sorry, of course, just plugged it in for the image."
May 3, 2009
Ulf replied to John Arne Birkeland's discussion Servo problem with the new red (328) cards?
"hi all, I'm not having RC-receiver connects. I just hook up the power by Gnd/VCC as in the Fig. The servos get 5V and they move, but very strange (ticking a while instead of moving 45 degrees as in the code out of the box). Or does the…"
May 3, 2009
Ulf replied to John Arne Birkeland's discussion Servo problem with the new red (328) cards?
"Here's the board, everything looks fine."
May 2, 2009
Ulf replied to John Arne Birkeland's discussion Servo problem with the new red (328) cards?
"Who's right? :) I got teh same issue, powering 5v to the board (2 pins on the top leftmost corner ), do i have additionally put power on batt pins too? The servos react in a strange way (shivering). any ideas?"
May 2, 2009
Ulf replied to Ulf's discussion ASCII Output
"Thanks, it worked. set it to 4800, now it works."
May 2, 2009
Reto replied to Ulf's discussion ASCII Output
"You do not have the same baud rate on your serial monitor and on ArduPilot. Check that out."
May 2, 2009
Ulf posted a discussion

ASCII Output

Hi,I'm running the code out of the box through Arduino IDE, when I monitor the serial port, i just get a bunch of symbols instead of the ASCII text. I tried some other terminals to check if its set to binary transmission. but no luck.any ideas?cheers,ulfit looks like this:f?`?~xf~3<`fL~`f?`?~xf~3<`?x~pf?`~xf~3`?x~`f?`?~xf~3`?x~f@See More
May 2, 2009
Ulf replied to Nick Sargeant's discussion Problems uploading code to Ardupilot.
"Thanks for the instruction link, Chris, totally overlooked that section. It was the Board setting: Arduino Diecimila or Duemilanove w/ ATmega168 instead of the right Arduino Duemilanove w/ ATega328 wohooou."
May 1, 2009
Ulf replied to Nick Sargeant's discussion Problems uploading code to Ardupilot.
"I got problems too: Ordered Ardupilot and the recommended FTDI-board, installed the virtual com-port drivers and get the error: "avrdude: stk500_recv(): programmer is not responding" when trying to upload with arduino. Prior to this i…"
May 1, 2009

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service