Brian Boyle
  • Male
  • Ajax, Ont
  • Canada
Share

Brian Boyle's Discussions

Problem with DIRDrones 2 axis camera mount

Started this discussion. Last reply by Brian Boyle Jan 16, 2012. 10 Replies

HI folks.I need some assistance with the a axis camera mount I purchased. The gears for the tilt axis do not mesh well at all. You can see here what I mean. Also one of my HS-55 servos has decided…Continue

has anyone flown this frame?

Started this discussion. Last reply by Adam Yaccarino Jan 15, 2012. 3 Replies

Continue

Has anyone used the Xbee24

Started this discussion. Last reply by Paul Feely Jan 18, 2012. 23 Replies

If so, can you tell me what I am doing wrong with the interface to the mission planner? it tries to connect but fails.I have followed all online documentation about set up. I have verified baud rate,…Continue

Copter rolls left

Started this discussion. Last reply by Brian Boyle Jan 3, 2012. 8 Replies

Hey folks.Can anyone help with this one? In the mission planner, the artificial horizon says the copter is level. I have done two auto levels in my basement but the copter still tries to fly to the…Continue

 

Brian Boyle's Page

Profile Information

About Me:
not much to say.
Please tell us a bit about your UAV interest
Arducopter of course.. this thing is awesome
Hometown:
Toronto

Brian Boyle's Blog

Acrylic Frame maiden flight

Posted on September 3, 2011 at 5:00pm 3 Comments

So this is the first flight on my second DIY frame. this one is entirely made from acrylic. It worked fine right off the bat. I did notice at about 28 seconds in it did a little seesaw and then stabilized fine. It worked really well until the second forth flight i was about 2 feet off the ground, just in a hover and it decided to flip upside down…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service