quix-fz
  • Male
  • Switzerland
Share
 

quix-fz's Page

Quix-fz's Blog

video of quadro

Posted on January 27, 2009 at 7:41am 1 Comment

nothing new since last post, but here's a video:





it might look stressful but keeping it this way was really easy, easier than my rc… Continue

supersimple esc's and quadro-update

Posted on January 26, 2009 at 4:00am 1 Comment

a little info i couldnt find anywhere else. while programming my quadrocopter, i somehow messed up the throttle start and end-points of one of the esc's. the motor started only when the throttle was already in the middle. after some googling and experimenting, i found out how to reprogramm the endpoints. this will probably work with other esc's too.



here's the exact procedure:



- connect esc to receiver and motor, do NOT connect battery

- on the (turned on) remote move… Continue

quadrocopter

Posted on January 23, 2009 at 9:30pm 3 Comments

a few weeks ago i decided to build a quadrocopter. this would be a real challange but still inside the capabilities of the pcb i made. i actually designed it with plane-uavs in mind. but there's no reason it wont be able to controll a quadrotor.



here's the finished board connected to a display. the display i a cheapo 128x64 graphics lcd controlled by… Continue

6-legged walking roboter

Posted on November 21, 2008 at 9:30am 0 Comments



slightly offtopic, but the servo-interface might be of interest to some people. here's my 6 legged walking roboter. there are 3 servos for every leg.…





Continue

prototype of my uav-pcb

Posted on July 10, 2008 at 12:30am 7 Comments



because there's no easy way to connect the arduino to a normal perf-baord (stupid 2mm space between digi7 and digi8) i decided to make it the right way from the beginning. so i downloaded eagle and played around the last few days. this is what has come out. :) i plan to use the arduino bootloader and just connect the few needed pins to a empty diecimila board for easy programming. all the traces are already handrouted.



i'll use the… Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service