taylor loper
  • Male
  • United States
Share
  • Blog Posts
  • Discussions (15)
  • Groups
  • Photos
  • Photo Albums
  • Videos

taylor loper's Discussions

Does this mean my board is browning out?

Started this discussion. Last reply by taylor loper Feb 21, 2013. 2 Replies

Continue

Tags: not, gui, working, only, cli

CLI works fine but none of the other tabs works

Started this discussion. Last reply by Rick H. Jan 29, 2013. 1 Reply

I'm currently using the firmware for arducopter 2.9 but it doesn't make a difference since I have the same exact problem with all the firmware. My APM 2.5 will connect to mavlink but in the…Continue

Tags: The, Flight, Data, stays, CLI

Remzibi OSD 3DR review

Started this discussion. Last reply by Cody Tomblin Mar 10, 2013. 1 Reply

The Remzibi OSD 3DR board is hard for me to review since it only worked for about 15 seconds. The board was able to connect to the Remzibi program but while uploading the firmware the board burned…Continue

Tags: 3DR, burned, out, fried, OSD

Erratic motor behavior

Started this discussion. Last reply by AntimatterCrusader Oct 25, 2012. 4 Replies

Watch the rear right motor. in the video it's usually on the far right. It starts acting erratic just randomly. I've held a hover for a number of minutes with no problems but then it just goes…Continue

Tags: malfunction, flip, erratic, motor

 

taylor loper's Page

Profile Information

Please tell us a bit about your UAV interest
I like programming

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service