3DR-Y6 modified with landing struts and clam shell cover.

Views: 201


Moderator
Comment by Nathaniel Caner on May 5, 2015 at 2:47pm

Hey Doug,

What is the all up weight of your Y6? Also what did you make the clam shell out of, it looks like the shell from a bicycle helmet?

Regards,

Nathaniel ~KD2DEY

Comment by Doug Walmsley on May 7, 2015 at 7:21am

I purchased the clam shells from OMGFLY.com in China and created a horizontal plate in the same shape as the oval pattern of the shell.  I drilled four holes around the shell and plate and used tie wraps to secure it in place.

As for the weight, I will weigh it this evening with all my specs for comparison.  That video shows the Y6 with the original motors and I've since swapped them out for 690Kv motors with 1247 props on top and 1347 props on the bottom.  Needless to say I have some serious power now and flight time as of late has been right around 10-12 minutes on 6000mAh 4S battery depending on flight mode.  my last hover test ran out to 12 minutes.

Comment by Doug Walmsley on May 10, 2015 at 8:59am

@ Nathaniel,

Forgot to reply back to my weight of the Y6B.  I weighed it minus batteries at 2350 grams (5.18 lbs).

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service