"That is very nice! What material are you using for the wing molds?"

"Are any companies retailing the unit in Europe?"

"[removed by moderators under TOS]"

"[removed by moderators under TOS]"

"Fantastic! What is the best way to buy this in Europe?"

"Interesting. I would like to build a gas engined helicopter, but I'd be concered about the autopilots ability to cope with engine failure. Correct me if I'm wrong, but I think that the current software would stall the rotors and the heli would crash…"

"I can't remember excatly how it was drawn in solidworks. But Convert Entities can be used in sketch mode to copy profiles. The section is an old Clark-Y, the profile is constant along the wing, this made fabrication easier. I think you could still…"

"Thank you,
I've also been following your work. For the wing boom mounts, I used part of the wing profile and did convert entity on the top side of the airfoil section, it can be helpful to save profiles as blocks in solidworks.
Constructing the boom…"

"The fuselage shell was vacuum bagged around a foam core. The foam was then dug out after the fuselage lid was cut off. The wind effect was similar to the X-frame. We were considering mounting the ESCs on the inside with heatsinks to keep it…"

"I am using the power module which should be able to supply the gimball servos. Next time I will use the BEC rail to power the servos"

"I had the same problem with my quad after installing a camera gimball. I think the servos drew to much current from the power module causing the autopilot to brownout and the quad to lose control. The Vcc log showed some transient under and over…"

"@Martin Poller
I thought about off the shelf cases, but I wanted something that I could chop and change to meet my requirements.
@UAVOZ

The Samsung monitor was supplied with a 14V mains adapter, I measured the output at 14.2V. I attempted to run…"