Ground stations (297)

Discussions Replies Latest Activity

Mission Planner language

Hi! I would like to know how can I change the language in the mission planning! I am using Win XP in Spanish, but I want the Mission Planne…

Started by Mauro Rodriguez

2 on Tuesday
Reply by Dwgsparky

Where is my terminal in mission planner?

A lot of doc on ardupilot.com refer to the terminal. But I can't see it on my own.

Started by Roben

2 on Sunday
Reply by Roben

Developer

Andropilot - discussion for Android ground controller users/developers

Hi ya'll, The thread on my blog post is getting a little unmanageable.  How about we discuss test results here instead...   I'll also post…

Started by Kevin Hester

834 on Saturday
Reply by Henri

MAV Proxy Module cannot be loaded up?

Hi, I have a question on MAVProxy. When I start MAVProxy, I got the following errors: Failed to load module: No module named wpFailed to…

Started by Edwin WIdjonarko

2 Jul 16
Reply by Safwen

Droidplanner 2 Nexus 7 map not shown

Hi, While connected to my drone(with my Nexus 7) the map shows just fine. But If I start droidplanner without being connected to the drone…

Started by Mathias

2 Jul 14
Reply by Mathias

Play back of telemetry logs in AndroPilot

Can anyone tell if .tlogs can be played back directly in AndroPilot?  If so, please give me a few tips on how to do it. Presently, I move t…

Started by Jim phelps

2 Jul 13
Reply by Jim phelps

Mission Planner on Linux

Hi, I'm trying to install Mission planner on Ubuntu 14.04 and not having much luck, I've followed the instructions on this thread: http://d…

Started by Mark Glover

3 Jul 7
Reply by Andre K.

Overriding Remote Control from a custom GS with MAVLink

Hello, I am trying to create a custom ground station that could take off the Quadcopter when a camera detects a predefined target. Basical…

Started by Valentin Brossard

28 Jul 3
Reply by Ruoyu Tan

Arm Quad by using c_uart_interface_example

Hi All, I am trying to use send_quad_commands.cpp in below link to send  override RC remote control commands to APM. Which value should I…

Started by Ruoyu Tan

0 Jul 3

Overriding Remote Control with MAVLink

Hi All, I am trying to send RC override command from serial port of my computer to the telemetry port of APM via MAVLink. But before that,…

Started by Ruoyu Tan

0 Jul 3

RSS

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service