My Project (486)

Featured Discussions

my diy ground control station

Well first of all I'll start with the reason I chose to build this ground station instead of using a laptop So after many times of carrying…

Started by elad orbachLatest Reply

Discussions Replies Latest Activity

can i build a quadcopter with this spec.

hello everybody. i need suggestion i wanna build a quadcopter with this following spec.. can it be done? 1. q330 totem frame 2. esc 20a 3…

Started by andi azhar

2 18 hours ago
Reply by andi azhar

APM MavLink to FrSky X8R S.Port converter

Hi all, I just bought an FrSky Taranis for my quad copter and needed to get the Mavlink data up on the Taranis LCD telemetry display. So he…

Started by Rolf Blomgren

1778 on Thursday
Reply by Paul Atherton

my new quadcopter built from scratch, but unstable - design problem?

Hello, i built quadcopter from scratch, including flight controller written in C and run on raspberry pi 3. there have special design and b…

Started by Aviv Cohen

9 Nov 26
Reply by Andy Little

DIY ESC/engine/propeller tester

Hi, I made engine tester based on arduino. I would like to ask you, if someone/something does exists ? I found only too expensive commercia…

Started by Ivosch

14 Nov 24
Reply by Ivosch

TriCopter for Ag Survey Work

My new TriCopter made its first long-duration test flight today, fully autonomous.  Using APM2.8, ArduCopter 3.2.1, APM Planner2 on linux.…

Started by Chris Olson

0 Nov 18

Feedback on Hex copter design

Hi all, I am currently doing research for building an optimal hex copter for long distance flights with heavy payloads. Since I have no exp…

Started by Takeoo111111

0 Nov 15

Is it possible to install larger motors and ESC's on a low-power quad?

Is it possible to install larger motors and ESC's on a low-power quad?I'd like to buy a lower-cost, intelligent quad and increase its lifti…

Started by Dan Jacob

12 Nov 10
Reply by Dan Jacob

Quadcopter with 1 hour flight time

Hey guys, Just wanted to introduce a new drone with 1 hour flight time: https://turncircles.com/products/drones-quadcopter-TC411

Started by Kaan Ozgen

57 Nov 10
Reply by Kaan Ozgen

800-1000 size custom carbon fibre Build - With Endurance [MEDIA HEAVY]

Welcome to my new build log, now aiming for the 40 minute mark with a new build / Modded h500 carbon pro

Started by Lunatix

2 Nov 3
Reply by Lunatix

4 pump boat (2 fwd facing + 2 facing backward ) pumps do not run backwards and is skid steer.

Hi all I hope this is the correct place to be asking this type of question. I have a fishing bait boat configured as in the title. I have a…

Started by Paul Edgell

0 Nov 2

RSS

© 2016   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service