PX4 and Pixhawk Hardware (1,010)

Discussions Replies Latest Activity

Pixhawk 2.1 cube failure

Hi! One of our Pixhawk 2.1 suddenly died, leds light up but it does not boot and the cube gets really hot. Anyone know if this is a common…

Started by Ivar Alendal

0 53 minutes ago

Questionable amount of vibrations on Lumenier Danaus with Pixhawk Mini

Hi guys. I have just finished assembling a new Quad intended for indoor flight using the Lumenier Danaus and the 3DR Pixhawk Mini. The buil…

Started by Thomas Jespersen

0 yesterday

Battery failsafe not triggering

Hi, I am an experienced flyer but this has me stumped, maybe one of you guys can help. The battery failsafe will not trigger even though th…

Started by Alex

4 on Tuesday
Reply by iSkyMaster

PixHawk power issues

Hi All, I was hoping someone could assist with some of the issues I have been having! I purchased a PixHawk FC second hand, and when conn…

Started by Jackson

1 on Tuesday
Reply by Jackson

Bad logging error in Mission planner

Dear Friends, My Mission Planner showing " Bad logging" error, please guide what will happen if I fly with that error. Flight control board…

Started by Yogesh Sonar

0 on Tuesday

How to connect DJI S900 rotors to Pixhawk?

Hello! I'm a newbie in the drone world. I've bought a DJI S900 and a Pixhawk and everything went well up to a point. As I don't want to me…

Started by Paul Berg

0 Jul 17

Octocopter spins with no stick input

I have a DJI S1000 octocopter powered by a Pixhawk2 running APM 3.4.6 and Mission Planner 1.3.48. When I take off in Stabilize mode, the co…

Started by Matthew Conrad

1 Jul 13
Reply by Matthew Conrad

external barometer for PIXHAWK

Hello, I’m trying to build a helicopter which can be operated under extreme environmental conditions (high humidity and light rain). For th…

Started by ChrisAT

2 Jul 12
Reply by peter morris

Using AUX pins as relays for CHDK

I'm confused and a bit frustrated, would appreciate any help as I'm not sure how to proceed. Setup: I have a pixhawk autopilot running Ard…

Started by Dave Williams

455 Jul 10
Reply by rupesh chandrawanshi

Signal Wire between Pixhawks

Hello, Is there anyway to connect a HIGH/LOW wire between two Pixhawks such that one can read whether the other is sending a high or low? A…

Started by Ryan Maxwell

0 Jul 5

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service