Hi guys,
I got another condition with APM here. My APM is just configured with default settings in v2.23. Flight modes are just Manual, Stabilize and RTL. On CLI and flight Data, I could see the modes with the flick of AUX1/ Flap switch. But when I install the APM to my Skywalker, only the Manual mode works where I can move the control surfaces correctly. Servos lock in Stabilize and RTL mode, even if I move the Skywalker. I've changed the Spektrum Rx's and Tx's to see if one is to fault but still, the flight modes don't work. Anybody can shed light on this? I'm at wits' end here.
Gent
Replies
Have you done the radio calibration? Do your radio min/max values look correct in the parameter list?
I have to add that when I switch to Stabilize mode, the motor runs full throttle, even if there is no input to the throttle channel.