Ok, I almost done with this, after 10 great flies with my skyfun jet, I just try to install my apm 1 with IMU board on one of my Quad and it did it again this is the no.3 apm board that suddenly stop working, the firts one stop to have signal input from the receiver , I replaced it, after many flies the second one just stop
conecting via usb no been able to load codes again the ATMEGA2560 stop working, now no3 just stop woking too all sensor are dead, all wired acoording to the manual, what is hapenning I doble everything help!!!!

Views: 63

Reply to This

Replies to This Discussion

Not good, Valentin! Got any pictures of your wiring? Maybe we can spot something that you missed.

jhon I did recheck my wiring, any ways I will send you picture...thanks

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Drone Delivery Challenge, is here

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service