Arduino Mega and OilPan

Greetings All,

I have two Arduino mega sitting around and would like to use one for my Quad. Any suggestions on how to use the ArduPilot Mega 1 IMU Shield/OilPan Rev-H V1.0 with the Arduino Mega 2560 board?

Thanks

0 members like this

▶ Reply to This

Replies to This Discussion

AdminPermalink Reply by Thomas J Coyle III on October 19, 2012 at 6:04pm

@AL,

The pin outs on the Oilpan are totally different from the Arduino Mega 2560 board. You might be able to hand jumper the correct pins from the Arduino Meg 2560 board to the corresponding pins on the Oilpan, but that will be a lot of work and probably prone to error!

Just a thought.

Regards,

TCIII

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	10k autonomous flight - telemetry guided flight, and other APM tests!
6	Drone shot down by police
7	ArduCopter-3.0 ready for wider use
8	MAAT final version is being tested
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	Thirty Days (#28): McMaster-116 lift

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.