Comment by Jeremy Tabb on September 18, 2012 at 5:00am

Hi, Does this mean you solder blobbed the contacts , so it doesnt run the 12v through the osd ?

i've read that it can heat up too much if you run 12v through it ?

Regards

Jeremy

Comment by Eagle on September 18, 2012 at 4:41pm

Jeremy, I don't connect 12V to the OSD.  My setup is explain here. I have hardware version 1.0. If I'm not mistaken you don't need to do this with the new hardware revision 1.1 since the heat issue is resolve.

Comment by prof.avi.levy on March 15, 2013 at 7:56am

Hi

It is not clear to me how do you power the OSD 12V side.

Could you please be more specific

Thanks

Avi

Comment by Jeremy Tabb on March 16, 2013 at 4:09am

Hello Avi, if you look at the link Eagle posted in the "my setup is explain here" there are two diagrams, my osd is version 1 so got too hot with 12v running through it , i used the second option in the diagrams which takes out the 12v supply ,it works great now , without the worry of it overheating in flight :)

 hope this helps :)

https://code.google.com/p/arducam-osd/wiki/How_to_start_minim

Comment by William Ishadi on March 25, 2013 at 1:04am

is it possible to use minim osd simultaneously with telemetry 433mhz from 3DR? 

i look up on the xbee board just 5v, ground, tx, rx. But in 433mhz 3DR teemetry module, there is 5v, ground, tx rx, and CTS, what this CTS and does it have to connect to minim osd?

Comment by William Ishadi on March 25, 2013 at 1:04am

i use APM 2.5 

Comment