Hello guys,I am building an FPV plane at the moment and want to do crop scouting with it. So I want to use telemtry to upload waypoints and edit the mission etc.I installed the recent ArduPlane fw…Continue
"Any luck buddy? Were you able to solve the issue you had with your XBee? I would have expected it be to pretty simple but does not seem so. I had connected CTS/RTS and at best I received a number of packet loss and unable to download the mission…"
"Hi Aakash,thanks for the info! I'm still stuck with this and use 433 MHz Antennas at the moment. But I would like to use the 868 XBees.Have you found out something meanwhile?Where are the guys they already made it and connected a XBee board to…"
I'm facing the exact same problem! When I try to connect 2 XBees through 2 differect PCs via Arduino, they communicate; but the moment I connect them to Pixhawk Telem1/Telem2 (I tried both ports) they just talk (I guess, as the Tx…"
I am having the same problem, and have spent quite a few hours trying to troubleshoot the issue. For my application, I need a long range radio and purchased two 250mW XBee-PRO-900s with RPSMA connector and 3dBi antenna. When connected to two…"
"The Xbee 868 has a low data rate, 24Kbps, & if you enable AES encription I believe it will be reduced further.
If the telemetry serial data rate is greater than the radios' RF transmition data rate there will be lost data.
"Hey there, Same problem!
I tried interfacing with Arduino but that works just fine but as soon as I get back to Pixhawk, it doesn't connect> I even tried with the PX4 flight stack in QGroundControl; still the same.. no connection.
"I Have the same issue. Worked fine on APM. Works fine USB to USB. As soon as I connect pixhawk to xbee, very dodgy.
The odd hearbeat comes through but that's it.
Scoped the pins coming out of pixhawk, can see the hearbeat,…"
Hello guys,I am building an FPV plane at the moment and want to do crop scouting with it. So I want to use telemtry to upload waypoints and edit the mission etc.I installed the recent ArduPlane fw (V3.5.2) and calibrated the mandatory hardware. I bought a pair of XBEE Pro 868 MHz modules with RP-SMA connector and set them up via XCTU software.I set them up with following settings:Modem VID: 105Destination Adress high: 0Destination Adress low: FFFFBaud Rate: 57600API offThe Groundstation is set…See More