Hello All,I've been trying to figure out how to tune the gimbal on my hexa using ArduCopter 2.7.3 Both pitch and roll movements are not proportional to the movement of the hexa and center points are…Continue
So I had a bit of a scare today. My hexa was set to loiter mode at about 10m altitude when all of a sudden it just took off like a bat out of hell, due North from its intended loiter position. I…Continue
Hi everyone,I've been trying to use the CH6 tuning option with no luck. I've set the CH6 option to CH6_RATE_KP and set the min and max values to 0.10 & 0.14 respectively before clicking Write…Continue
Hi Everyone,I recently setup a new hexacopter and loaded ArduCopter 2.5.5. I'm using an APM 1. After plugging in the battery and using wireless telemetry to connect to the Mission Planner the…Continue
Try to do this with your quad! The cup is not attached. If you pay close attention to the cup, you'll notice it sliding back and forth during maneuvers. That's just too cool!
Jago Svensson is a talented aerial photographer and all around tinkerer. I'm sure you'll also enjoy checking out his website here: …Continue
I recently noticed these cameras in one of my local stores. By the looks of it they are basically built along the same lines as the GoPros. I'm not sure how they compare, but if anyone has any experience with these little cameras, please feel free to post you comments. You can find more info on their website here: …Continue