zmooth
  • Male
  • Attica
  • Greece
Share

Zmooth's Friends

  • DeltaMan
  • Phillip
  • David Anders
  • Adrian Mescalchini
  • Paolo
  • James
  • Nikos Gerarchakis

zmooth's Groups

zmooth's Discussions

Help me diagnose why my outputs don't work properly:(

Started this discussion. Last reply by zmooth Mar 31, 2014. 1 Reply

At this point I'd appreciate anyone's help, I am all out of ideas. I tried a new APM (2.5.2 board) but I can't get my gimbal (or any other device for that matter) to receive correct PWM signal. The…Continue

On using BL motors as gimbal actuators

Started this discussion. Last reply by zmooth Dec 19, 2012. 2 Replies

Some really good work being done in Russian, check it out !http://forum.rcdesign.ru/blogs/97312/…Continue

Weird behavior of APM1(2560) radio/ppm - channel 6

Started this discussion. Last reply by zmooth Oct 28, 2012. 3 Replies

I am having this very weird problem : it seems as if rc channel6 is not being received. Mission Planner shows ch6in stays at 1500 but I am possitive the Rx is sending signal correctly (tried a few…Continue

Help! Second board that I receive appears defective :(

Started this discussion. Last reply by zmooth Jul 2, 2011. 2 Replies

I have been trying to setup my quad for a few months now, delayed hugely by the first board I received pre-assembled which was defective: no radio signal was coming in.I have just received my…Continue

 

zmooth's Page

Profile Information

About Me:
dimitri aka zmooth
Please tell us a bit about your UAV interest
<3 * with rotary wings
Hometown:
Athens

Zmooth's Blog

3d printed GoPro lens mount

Posted on March 19, 2013 at 1:01am 4 Comments

Check out my 3d printed GoPro Hero 3 lens mount

Thingiverse link

Works great on QAVs, TBS Disco etc

Planning to add some protection (something like a…

Continue

3d printed uBlox GPS case

Posted on March 5, 2013 at 2:00pm 9 Comments

Made this simple case for the 3dr uBlox GPS

thingiverse link

 

It's made out of three parts in order to fit a reflector(shield) between the mid and bottom sections.I used thin copper plate but any conductive material should work.

Just ignore bottom…

Continue

Comment Wall

  • No comments yet!

You need to be a member of DIY Drones to add comments!

Join DIY Drones

 
 
 

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service