Discussions

6s on adm

Posted by rick gonzales on July 24, 2013 at 10:47pm

hello all

im new to the multicopter thing..ive ordered all i need, ive done tons of research here and anywhere eldse i can to get hoing in the right  direction.

only thing im at is would it be possible for someone to point me in the right direction here... im using opto isolated escs, ill be using a 5 volt bec..that part is easy enough.. the part i havent figured out is, if i hook up the 6s to the power module..is it going to cook it..

i found the atto board..is there by chance a diy on that ..how to swap it out ,,schematic...any help would be appreciated...unfortunately i will not be able to give back in any form other than donating where i can..

 

excuse the trping errors, i have only one working arm..

regards

Ret.

SGT. gonzales

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • rick gonzales July 25, 2013 at 5:28pm

    i got it figured out

  • rick gonzales July 25, 2013 at 12:12am

    once i setup the atto board, do i still need to add a switching bec to power the apm... the analog output of the atto is 3.3.. not enough to power the apm

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…