8chTX...6chRX...Radio-Issue

 

I-have-an-8ch-TX-flying-6ch-RX-radio-issue?

 

All-is-well-in-Manual-Mode.

 

In-Stabilize-or-FlyByWireA-the-control-surfaces-dance-with-travel-between-an-eighth-and-three/eights-inch-while-the-servos-cycle-through-a-sequence-reminiscent-in-sound-to-the-GallopingGhost.

 

Is-there-a-code-tweak-to-reduce-or-eliminate-this-problem?

 

 

AP/v2.7.1

ArduIMU-V2-(Flat)/v1.7

 

RX-6ch-Corona-RS-610-II

TX-8ch-Polk-TrackerIII-PPM/FM

 

All-is-well-with-a-6ch-TX-(Futaba-T6XA-PPM/FM)-flying-the-same-model.

 

John

 

Please-pardon-the-dash”-“myspacebarbitthedust

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Moderator
    In the header file I think you should try change the following

    #define RADIO_TYPE 0 // 0 = sequential PWM pulses, 1 = simultaneous PWM pulses

    Also turn on debug mode to 1 and see what radio inputs you are getting, they should read constant values when you are not moving your TX of between 1000 - 2000 approx. Remember to turn debug off again before flying or else AP will not work
  • Is-it-just-me-or-is-AP/2.7.1-outputting-peridoc-rubbish?

    John
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…