1. FC : Pixhawk clone
2. Frame : U580 Pro ( Retract included. http://www.himodel.com/multi_rotors/HMF_U580Pro_Umbrella_Folding_Quadcopter_Frame_Kit_High_Landing_Gear_w_Gimbal_Hanging_Rail.html)
3. Tx : Taranis X9D
4. Rx : FrSky X6R
5. MP : 1.3.30.3 ( beta version )
I set AC3.3 just following below article
http://copter.ardupilot.com/wiki/common-optional-hardware/landing-gear/
Retract signal --> AUX1 ( not ground pin )
RC9_FUNCTION = 29
LGR_SERVO_DEPLOY = 1750
LGR_SERVO_RTRACT = 1250
Ch7 opt = Landing Gear
Taranis.CH7 = 3 position switch
But my retract didn't act.
It didn't work even with Taranis.Ch7 high and low position ( manual control )
Direct connection between retract and rx ( X6R.Ch14 = Rx.Pin.6 ) works fine
It'll be very appreciated if anyone find what I missed
P.S : I've tried RC10 and Ch8 option = Landing Gear but no working
Replies