Discussions

APM 2.6 Jumper and power Module

Posted by Grandpa Jake on November 11, 2014 at 12:07pm

Hello, I am building my first Quad copter and with my kit came the Arducopter 2.6 also a Power module. I am a little confused as I read more about removing jumper 1 is this something I need to do or should I leave the jumper in. Any help would be greatly appreciated so I don't damage anything.

Grandpa Jake

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Joe Breznai November 11, 2014 at 3:27pm
Note for ArduCopter users:
- You should normally remove the APM’s JP1 jumper when using the Power Module so that only your APM board and your receiver are powered from the Power Module’s on-board regulator and not from your ESCs.
From:

http://copter.ardupilot.com/wiki/common-measuring-battery-voltage-a...

Joe

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

Replies

Note for ArduCopter users: