I've just tried to configure my APM/Oilpan with APM Planner 1.0.82
Updated firmware ok, rebooted ok
Connected up again and clicked the APM Setup button.
Reset APM to default
Clicked the radio input button, nothing happening on screen when i move the sticks around and i get a "missing rev param".
Radio is a DX8 with it's 8 channel receiver in DSMX mode
Could anyone help please?
Replies
Is your CLI switch in the flight position? Is your radio powered?
Have you had success with the DX8 before and APM before? Some people find it tricky to bind. See the Troubleshooting Guide for instructions.