Discussions

Arducopter frame alternative.

Posted by Raytrace Nomad on August 19, 2010 at 11:45am
I plan to make frame with Trex 600 tailboom and 3mm plywood.

               A
                |
                |
                |
B ---------Center--------- C
                |
                |
                |
               D

I plan to use Turnigy 2217 860 kV with 12X3.8

One tailboom 21.5mm diameter / 625mm lenght. 70gr

Could you estimate A to center lenght ?  Any ratio ?


You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Michael Abraham August 28, 2010 at 8:31am
    Hi this is my CoCo Frame,
    made from 5mm Birch Plywood and each side 2 Layers GFK.

    If someone need a 1:1 JPG sketch. Mail me please


    Mike
  • Developer
    Jani Hirvinen August 19, 2010 at 12:42pm
    Around 30cm would be ok. Most outdoor quad uses 60cm engine to engine distance due it has been proven to be best length. You can also check AeroQuad.com for nice building instructions with Trex booms.
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…